Setup Wifi Range Extender (WiFi booster)
Plug range extender into a power socket only (don’t connect ethernet yet).
Connect to the network “Repeater-4315” or similar named network, this network should be open and require no password.
Once connected use a browser to navigate to http://192.168.11.1/ and click LOGIN as shown below:
Connect to the network “Repeater-4315” or similar named network, this network should be open and require no password.
Once connected use a browser to navigate to http://192.168.11.1/ and click LOGIN as shown below:
 |
On the next screen click NEXT on AP Mode Settings |
 |
Setup your extenders Network Settings as below setting the SSID (the name of the WiFi network), your WiFi Password and then click NEXT: |
 |
Make a note of the SSID and WiFi Password you set on the previous screen and click FINISH |
 |
Allow 30 seconds for the changes to take effect and the extender to restart: |
 |
You can now remove the extender from the power, connect the Ethernet cable supplied to the extender and then to the router and plug the extender into the power. Once again allow 30 seconds for the extender to start up. Finally connect your energyGuard Hub to the Extender network with the details you saved earlier. |