Recalibrate touch screen (there are dots flashing on the screen)

Recalibrate touch screen (there are dots flashing on the screen)

If the dots are already flashing on your touch screen, skip to step 5. 

Tap MENU on the Home screen:
  1. Select Device Info
  2. Press Reboot
  3. During the boot countdown sequence tap the top right-hand corner of the screen. There is no visible button. You will have 10 seconds to access that screen. Don't worry if you miss it, just try again by repeating this step. 
    Result: The Boot menu will be displayed
  4. On the boot menu select Advanced and on the new screen select Recalibrate.
    Result: The new screen will show dots on a different part of the screen
  5. Use a pen or something pointy to press the dots exactly where they show and that's it


    • Related Articles

    • energyGuard Hub screen is blank or unresponsive

      Step 1: Get the safety tool If your screen happens to go black, you can try performing a hard reboot to resolve the issue. A hard reboot involves the removal and reattachment of the front panel. You can use the safety tool in the image below to take ...

    • energyGuard Hub won't turn the heating on

      There are several potential issues that can arise in a heating system, making it challenging to determine the root cause. Problems may arise with the boiler, water pump, motorized valves, radiators, or even the thermostat. Fortunately, there are ...

    • energyGuard Hub clicks when turning the heating ON or Boost

      Hearing the click means the energyGuard Hub is working fine. It means the issue is somewhere else in your heating system. There are a few more things you can try to eliminate some simple issues with the heating system. Check fuel supply If you have a ...

    • Installation guide

      Step 1: Turn off the power To avoid the risk of electric shock, it is essential to switch off the power supply to your heating controls. Step 2: Remove your current heating controls Hopefully, you’ve taken the advice from Step 1 onboard and you can ...

    • Setup Wifi Range Extender (WiFi booster)

      Plug range extender into a power socket only (don’t connect ethernet yet). Connect to the network “Repeater-4315” or similar named network, this network should be open and require no password. Once connected use a browser to navigate to ...